In the daily printing work, we found that card printing design often a variety of problems, in order to avoid errors and improve efficiency, we summed up the mechanical and electrical tag printing design considerations.

The first point: the distance, the layout of the text (or picture) from the cutting edge must be 3mm, so as not to cut to cut to. After the text turns into a curve, notice whether there is a jump or overlapping between words. Text must be curved or outlined. Do not use the system word, if used will cause the printed strokes to have white nodes in the stagger. If there is a white node in the stagger, it can be handled by the broken instruction. Do not use black text overlay coloring.

The second point: can not print the color of the printer to request printing colors, customer design must refer to the percentage of CMYK chromatography to determine the design color. At the same time note: CMYK chromatogram produced by different manufacturers by the use of printing paper, printing ink types, printing pressure and other factors, there will be some differences in the same color.

The third point: tag printing manufacturers in different versions of printing, the color will be different, the color difference in 10% of the normal (due to print ink control each time there will be different).

Fourth point: the design of the color of the color block Please try to avoid the use of dark or full version of the color combination to avoid the resulting print after cutting back India situation. As a result of less printing, the positive and negative sides have the same large area of color, and occasionally there will be ink points.

Fifth: tag shading or base map color should not be less than 10%, otherwise the finished product can not be rendered.